RE: CIPE on raq3|
"Lukasz Michalski" <zork,AT,clan,DOT,pl>|
Sat, 17 Feb 2001 12:27:29 +0100|
Yes, I've found a solution.
It looks like Cobalt messed something up with the kernel. I downloaded
original 2.2.18 kernel and recompiled it adding Cobalt LCD support. It works
- it doesn't have any other Cobalt kernel modifications like Cobalt
bandwidth limiter, watchdog and temperature meter.
- becouse of lack of watchdog systerm doesn't reboot. It shut downs fine
but can't start and you must turn power off and on. I don't know if its true
but I think it's becouse lack of watchdog - Cobalt doesn't have standard
BIOS, and kernel uses bios routines to reboot.
- Cobalt modified network card EPROM and driver from 2.2.18 (eepro100.c)
doesn't work. I've replaced it with driver 2.2.14 and it works.
and Cipe works fine :)
If you want, I can put modified sources of this kernel on ftp.
Besides, I think adding the rest of Cobalt modifications to the 2.2.18
kernel shouldn't be much work, but I don't have so much time now to do it.
> -----Original Message-----
> From: Jim Roberts [mailto:jim,AT,macsourcery,DOT,com
> Sent: Saturday, February 17, 2001 2:43 AM
> To: Michael
> Subject: CIPE on raq3
> I have the same problem you posted to the CIPE list:
> Did you figure out a solution?
> Any help you can offer would be appreciated.
> I've tried to compile and run cipe on Intel linux 2.2-14. (Cobalt Linux
> Raq3) and got following errors:
> [root cipe-1.4.6]# /usr/local/sbin/ciped-cb
> CIPE daemon vers 1.4.6 (c) Olaf Titz 1996-2000
> Using cipcb0 index 0
> opendev: attach: Address family not supported by protocol