<< | Thread Index | >> ]    [ << | Date Index | >> ]

Subject: Re: Setup/routing question with cipe
From: Peter van den Heuvel <peter,AT,asylum,DOT,xs4all,DOT,nl>
Date: Fri, 10 Aug 2001 12:05:03 +0200
In-reply-to: <F349BC4F5799D411ACE100D0B706B3BB76906F@umr-mail03.cc.umr.edu>

Yo Nathan,

> First, I can't get it to work with pkcipe AT ALL. Nothing will ever go
> over the link, most likely due to the screwy address it is choosing for
> the peer on the server side. (The server's default outbound route
> crosses a 10.0.0.x network, and it's picking 10.0.0.254 as the peer
> address.) I tried all sorts of contortions with specifying options/etc,
> and never had any luck getting it to link up properly. When I hand wired
> everything in and ran ciped-cb by itself, it worked right away.
Cool! Any usefull errors maybe?

> The second problem, in order to get the source-based routing to work, I
> had to do this on the client router:
Why actually are you turning to source based routing? You simply got two
nets and a default gateway. If you cannot get it going with normal
routing, you're missing something simple yet essential. Don't turn to
something more exotic to work around a gap in your knowledge. If you
have the simple routing table, put it on the list so we can look at it.
Most usefull...

My routing table:
10.5.254.1      0.0.0.0         255.255.255.255 UH    0      0        0
cipcb3
10.3.254.1      0.0.0.0         255.255.255.255 UH    0      0        0
cipcb0
my.own.ip.addr  0.0.0.0         255.255.255.255 UH    0      0        0
ppp0
10.0.0.0        0.0.0.0         255.255.255.0   U     0      0        0
eth0
10.1.1.0        0.0.0.0         255.255.255.0   U     0      0        0
eth1
172.16.0.0      0.0.0.0         255.255.248.0   U     0      0        0
eth2
10.4.0.0        10.5.254.1      255.255.0.0     UG    0      0        0
cipcb3
10.5.0.0        10.5.254.1      255.255.0.0     UG    0      0        0
cipcb3
10.0.0.0        10.3.254.1      255.0.0.0       UG    0      0        0
cipcb0
127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0
lo
0.0.0.0         my.own.ip.addr  0.0.0.0         UG    0      0        0
ppp0

Yes, there are four NIC's in my server at home (is also office), there's
two routes over cipcb3: the native 10.5 and the 10.4 that's again behind
the 10.5, All other 10 ranges are behind the 10.3, 10.1 is local, the
10.0 is something from the ADSL gadget and is of no other use, ppp0 is
the Internet and default route. Note the the routes are always displayed
sorted by netmask (with a reason)!

CIAO





<< | Thread Index | >> ]    [ << | Date Index | >> ]