cipe on a floppy|
"Peter Berghmans" <palmkes,AT,send-e,DOT,net>|
Tue, 4 Jun 2002 22:49:30 +0200|
Like I stated earlier on this mailinglist, I was trying to put cipe on a
floppy-based firewall/vpn solution. I use floppyfw (www.zelow.no/floppyfw)
for this. Cipe has version 1.4.6.
The result of my work is that cipe exits with the message 'cipecb: missing
argument: peer'. Below the steps I have done.
1. Compiled kernel 2.2.20 (with versioned symbols and ipforwarding).
2. Compiled cipe against the source of 2.2.20 (once with the option
--disable-dyndev and once without. No difference as result).
3. Copied the new kernel, together with
???? to the floppy and booted with this
4. load the module with 'insmod ciped.o'
5. check the module with lsmod (ok)
6. start the config with 'ciped-cb -o /etc/cipe/options device=cipcb0'
(...where things go wrong)
here is the contents of 'options':
As you can see, peer is there, but I don't think this is the problem.
Note: my floppyfw has only insmod as tool to handle modules. modprobe isn't
provided. this is why I setted the --disable-dyndev option at config-time.
Is there anyone who can help me out with this?
Note: my previous question was about a segmentation fault while starting
ciped-cb. This was because of wrong libs. This problem has been solved... So
the libs are ok!